No need to buy an expensive and hard to maintain DTF printer, let us print your designs for you and ship them same day. 

The more you print the more you save with our multiple sheet sizes:

22" X 24" - $34.99 | 22" X 36" - $49.99 | 22" X 48" - $59.99 | 22" X 60" - $79.99 | 22" X 120" - $109.99 | 22" X 180" - $129.99 | 22" X 240" - $149.99

Bundle up your designs and cut them apart when you receive the sheet.  *Even if you need only one design it's often a good idea to print an extra just in case the first one gets messed up.

Where can I use DTF Film?  It can be transferred on to any fabric regardless of material or color

How long with the print last on the garment?   Under testing the DTF print shows no degredation through 60 washings.

To ensure your DTF transfer looks professionally pressed every time, follow these five simple steps. 

(printout included with your order)

1. No need to Pre-Press Or Pre-Iron: Removing moisture is unnecessary. Only do a prepress if you want to remove wrinkles for a smoother surface.

2. Position Your Design: Take your time to line up your transfer in the desired location on your item. Normally, there is no need to use heat-resistant tape on flat heat presses to keep your design in place, however it is highly recommended when pressing transfers onto hats or when using an iron to keep the transfer in place. 

3. Press: Press your transfer with medium pressure at 310°F / 155°C for 15 seconds. You cannot damage the transfer by pressing with more heat, pressure, or time -- within reason. However, too much heat can damage your garment, so test first and use parchment paper or a protective guard sheet to protect your garment from a direct iron.

4. Let It Cool. Then Peel It: After pressing, let your transfer rest until it is cool to the touch (minimum of 15-30 seconds).  Once cool, lift the transfer from one corner and gently peel back.  This ensures every piece of your design is adhering to your item. If not, stop peeling, lay it back down, and trouble shoot as follows -- (1.) If some or all of the design does not transfer AND it was cool when peeling, it means there was not enough heat, pressure, or time. Press your transfer again with more pressure and time first (+5-10 seconds). (2.) If that doesn’t work, try 15°F heat increments until you find the sweet spot. You truly cannot damage the transfer by pressing multiple times.

5. Final Press & Wash Instructions: Place the parchment paper included or a single layer of t-shirt material over the design and press again for 15 seconds to soften the design, increase durability, and remove shine. If you want a shiny finish, cover with a protective guard sheet for the final press. When washing, flip shirt inside out, wash on cold and dry using low heat or hang.